how to jump start a car

How to jump start a car the right way in 2022

Everyone wants to derive utility from the brand of car that they’ve purchased and are using for their daily endeavors. However, there are cases where scenarios that were not envisaged materialize. Just imagine a scenario where you have to be at a place in a timely fashion and your car won’t start. How do you go about resolving this?

Well, this article will teach how to jumpstart a car in 2022 and we dare say in subsequent years unless car technology changes. With research, we’ve come up with an ideal method that will help you with answers to the question of how to jumpstart a car correctly. Please read on!

The Right Way to Jump Start a Car

Before you go about the process of how to jumpstart your car or any other car, some requirements have to be met with regards to the tools that should be available. 

Do well to find a set of jumper cables and another car that you can use to get a jolt. A colleague’s car would suffice in this situation. Once you have the aforementioned in place, follow the processes listed below:

jumper cables

  1. Park the car with a good battery for the jolt near the affected vehicle in such a way that their hoods are close and almost touching. Engage both parking brakes and ensure that the two vehicles are turned off before you proceed further.
  2. Open the hoods of both cars and locate their batteries. Occasionally, you will find the battery covered by a plastic hood.
  3. identify the positive and negative terminals on both batteries. The positive is the red terminal while the black is the negative terminal. Do well to clean them, if they are dirty. Once this is done, you can proceed.
  4. Connect the red clamp to the dead battery’s positive terminal
  5. Proceed by uncoiling the battery cable and hooking up the other red clamp to the live vehicle’s positive terminal.
  6. Face the good battery and connect the black end of the cable to the negative terminal.
  7. Return to the vehicle that has the dead battery, and connect the last black cable clamp to an unpainted metal surface on the car’s frame. Do well to note that it is flat.
  8. As all the connections have been established in the right places, start the engine of the working car and leave it for a few moments to ensure that a charge is passed to the dead battery.
  9. Once this is done, attempt to start the car with the dead battery. If the car doesn’t jumpstart, then you’ll need a reliable jump-start car service.
  10. If the former is not the case and the car starts, carefully remove the cables and reverse the order in which they were connected. Avoid letting the ends touch until all parts have been removed.
  11. Allow the jump-started car to run for at least ten minutes so that the battery can recharge while the other car can be shut off immediately.

Some Battery Tips and Tricks

Meanwhile, if your efforts to jump start the car didn’t work out as envisaged, try not to be overly frustrated and take advantage of these tips below:

  • If you only hear a clicking sound when trying to start the car, the car battery may be fine although your starter may have an issue.
  • If you manage to get your vehicle’s electrical system back to life and the engine is still not starting, your vehicle’s ignition switch, fuses, or starter may have developed a fault. Do not overlook the possibility of a flat dead battery too.
  • If you succeed with the jump-starting method and your car battery dies again a while after you get on the road, your car’s alternator may be weak


Leave a Reply

Your email address will not be published.